DTC P0705: Transmission Range Sensor Circuit Malfunction (PRNDL Input) [08/2015 - 08/2019]: Description

WARNING: This page is about a different variant/trim than selected.

The Park/Neutral Position (PNP) switch detects the shift lever position and sends signals to the ECM.

DTC Code	DTC Detection Condition	Trouble Area
P0705	One of the following conditions is met: (A) Any 2 or more of the following signals are ON simultaneously (2-trip detection logic): P input signal is ON N input signal is ON NSW input signal is ON R input signal is ON D input signal is ON (B) Any of the following signals is ON for 2.0 sec. or more with the shift lever in S (2-trip detection logic): P input signal is ON N input signal is ON NSW input signal is ON R input signal is ON (C) All switches are OFF simultaneously for P, R, N, D and NSW (2-trip detection logic).	Open or short in park/neutral position switch circuit Transmission control switch (transmission floor shift assembly) Park/neutral position switch ECM

DTC Code

DTC Detection Condition

Trouble Area

P0705

One of the following conditions is met:
(A) Any 2 or more of the following signals are ON simultaneously (2-trip detection logic):

(B) Any of the following signals is ON for 2.0 sec. or more with the shift lever in S (2-trip detection logic):