Inspection [08/2015 - 08/2019]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT TRANSFER INDICATOR SWITCH (4WD POSITION)
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
| Tester Connection |
Switch Condition |
Specified Condition |
| 1 - 2 |
Pushed |
Below 1 Ω |
| 1 - 2 |
Not pushed |
100 kΩ or higher |
If the resistance is not as specified, replace the switch.
- INSPECT TRANSFER INDICATOR SWITCH (L4 POSITION)
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
| Tester Connection |
Switch Condition |
Specified Condition |
| 1 - 2 |
Pushed |
Below 1 Ω |
| 1 - 2 |
Not pushed |
100 kΩ or higher |
If the resistance is not as specified, replace the switch.