Replacement [08/2015 - 08/2019]: Procedure

WARNING: This page is about a different variant/trim than selected.

DRAIN TRANSFER OIL
Refer to PROCEDURE - Step 1
REMOVE REAR PROPELLER SHAFT ASSEMBLY
(Refer to REMOVAL [08/2015 - ] )
REMOVE REAR OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
See step 7
REMOVE REAR TRANSFER OUTPUT SHAFT COMPANION FLANGE OIL SEAL
See step 8
REMOVE TRANSFER CASE REAR OIL SEAL

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Using SST, tap out the transfer case rear oil seal.
  - SST: 09308-00010
  NOTE:
  Be careful not to damage the transfer case rear oil seal and rear case contact surface.
INSTALL TRANSFER CASE REAR OIL SEAL

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Coat the lip of a new transfer case rear oil seal with MP grease.
2. Using SST and a hammer, tap in the transfer case rear oil seal until its surface is flush with the rear case upper surface.
  - SST: 09223-46011
  - SST: 09631-32020
INSTALL REAR TRANSFER OUTPUT SHAFT COMPANION FLANGE OIL SEAL
See step 44
INSTALL REAR OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
See step 46
INSTALL PROPELLER SHAFT ASSEMBLY
(Refer to INSTALLATION [08/2015 - ] )
ADD TRANSFER OIL
See step 2
CHECK FOR TRANSFER OIL LEAK