LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> 4Runner Limited, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Transfer Case (VF2A) - Service Information) >> Transfer Indicator Switch >> Inspection [08/2015 - ] >> Procedure

Inspection [08/2015 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT TRANSFER INDICATOR SWITCH (4WD POSITION) 
    GTY294177Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Switch Condition Specified Condition
      1 - 2 Pushed Below 1 Ω
      1 - 2 Not pushed 100 kΩ or higher

      If the resistance is not as specified, replace the switch.

  2. INSPECT TRANSFER INDICATOR SWITCH (L4 POSITION) 
    GTY294177Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Switch Condition Specified Condition
      1 - 2 Pushed Below 1 Ω
      1 - 2 Not pushed 100 kΩ or higher

      If the resistance is not as specified, replace the switch.

  3. INSPECT TRANSFER INDICATOR SWITCH (NEUTRAL POSITION) 
    GTY230405Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Switch Condition Specified Condition
      1 - 2 Pushed Below 1 Ω
      1 - 2 Not pushed 100 kΩ or higher

      If the resistance is not as specified, replace the switch.

scientia non olet · About LEMON Manuals