Replacement [08/2015 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

DRAIN TRANSFER OIL
See step 1
REMOVE FRONT PROPELLER SHAFT ASSEMBLY
1. Remove the front propeller shaft (Refer to REMOVAL [08/2015 - ] ).
REMOVE FRONT OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
See step 8
REMOVE FRONT TRANSFER OUTPUT SHAFT COMPANION FLANGE OIL SEAL
See step 9
REMOVE TRANSFER CASE FRONT OIL SEAL

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Using SST, tap out the oil seal.
  - SST: 09308-00010
  NOTE:
  Be careful not to damage the oil seal and case front contact surface.
INSTALL TRANSFER CASE FRONT OIL SEAL

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Coat the lip of a new oil seal with MP grease.
2. Using SST and a hammer, tap in the oil seal until its metal ring contacts the case.
  - SST: 09649-17010
  - SST: 09950-70010
    1. 09951-07100
INSTALL FRONT TRANSFER OUTPUT SHAFT COMPANION FLANGE OIL SEAL
See step 43
INSTALL FRONT OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
See step 44
INSTALL FRONT PROPELLER SHAFT ASSEMBLY
1. Install the front propeller shaft (Refer to INSTALLATION [08/2015 - ] ).
ADD TRANSFER OIL
See step 2
CHECK FOR TRANSFER OIL LEAK