Inspection [08/2015 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT TRANSMISSION WIRE (ATF TEMPERATURE SENSOR)
- Measure the resistance according to the value(s) in the table below.
Standard resistance
Tester Connection ATF Temperature Specified Condition 2 (OT-) - 10 (OT+) 10°C (50°F) 5 to 8 kΩ 2 (OT-) - 10 (OT+) 25°C (77°F) 2.5 to 4.5 kΩ 2 (OT-) - 10 (OT+) 110°C (230°F) 0.22 to 0.28 kΩ 1 (OT2-) - 9 (OT2+) 10°C (50°F) 5 to 8 kΩ 1 (OT2-) - 9 (OT2+) 25°C (77°F) 2.5 to 4.5 kΩ 1 (OT2-) - 9 (OT2+) 110°C (230°F) 0.22 to 0.28 kΩ TEXT IN ILLUSTRATION*a Component without harness connected
(Transmission Wire)HINT:
If the resistance is out of the specified range at one of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.
Resistance (Reference)
ATF Temperature Specified Condition 10°C (50°F) 5 to 8 kΩ 25°C (77°F) 2.5 to 4.5 kΩ 110°C (230°F) 0.22 to 0.28 kΩ If the result is not as specified, replace the transmission wire.
- Measure the resistance according to the value(s) in the table below.