Inspection [08/2015 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT TRANSMISSION CONTROL SWITCH
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 3 (IG) - 7 (S) Shift lever in S, "+" or "-" Below 1 Ω 3 (IG) - 7 (S) Shift lever not in S, "+" or "-" 10 kΩ or higher TEXT IN ILLUSTRATION*a Component without harness connected:
(Transmission Control Switch)If the result is not as specified, replace the transmission floor shift.
- Measure the resistance according to the value(s) in the table below.