LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> 4Runner Limited, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission System (A750E) - Service Information) >> Park / Neutral Position Switch >> Installation [08/2015 - ] >> Procedure

Installation [08/2015 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Install the switch to the manual valve shaft.
    2. Temporarily install the bolt.
      GTY280207Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install a new lock washer and the nut.

      Torque: 6.9 N.m (70 kgf/cm, 61 in.lbf) 

    4. Turn the control shaft lever LH clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.
      GTY715509Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Align the neutral basic line with the switch groove.
      GTY729669Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Neutral Basic Line
      *2 Groove
    6. Hold the switch in position and tighten the bolt.

      Torque: 13 N.m (130 kgf/cm, 9 ft.lbf) 

    7. Using a screwdriver, bend the tabs of the lock washer.
    8. Connect the switch connector.
  2. INSPECT SHIFT LEVER POSITION 

    See step  1

  3. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY 

    See step  1

scientia non olet · About LEMON Manuals