LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> 4Runner Limited, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission System (A750E) - Service Information) >> Extension Housing Rear Oil Seal >> Replacement [08/2015 - ] >> Procedure

Replacement [08/2015 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE PROPELLER SHAFT ASSEMBLY 
    1. Remove the propeller shaft (Refer to REMOVAL [08/2015 - ] ).
  2. REMOVE AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL 
    GTY702391Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Using SST, remove the oil seal.
      • SST: 09308-00010 
  3. INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL 
    1. Coat the lip of a new oil seal with MP grease.
    2. Using SST and a hammer, tap in the oil seal.
      GTY740351Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09316-60011 
        1. 09316-00011
        2. 09316-00051

      Standard depth

      5.4 to 5.8 mm (0.213 to 0.228 in.)

  4. INSTALL PROPELLER SHAFT ASSEMBLY 
    1. Install the propeller shaft (Refer to INSTALLATION [08/2015 - ] ).
  5. ADD AUTOMATIC TRANSMISSION FLUID 
    1. Add automatic transmission fluid (Refer to ADJUSTMENT [08/2015 - 08/2019] , or refer to ADJUSTMENT [08/2019 - ] ).
scientia non olet · About LEMON Manuals