Replacement [08/2019 - ]: Procedure

WARNING: This page is about a different car, the 2024 Toyota 4Runner, 2023 Toyota 4Runner, 2022 Toyota 4Runner, 2021 Toyota 4Runner, and 2020 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.

DRAIN TRANSFER OIL
See step 1
REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
Refer to REMOVAL [08/2015 - ]
REMOVE REAR OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
Refer to PROCEDURE - Step 9

REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL

Using SST, remove the transfer extension housing type T oil seal.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

SST: 09308-00010

NOTE:

Be careful not to damage the transfer extension housing type T oil seal and extension housing contact surface.

INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL

Coat the lip of a new transfer extension housing type T oil seal with MP grease.

Using SST and a hammer, install the transfer extension housing type T oil seal as shown in the illustration.

SST: 09631-12090
SST: 09950-60011
1. 09951-00600
SST: 09950-70010
1. 09951-07100

Drive in depth (A)

48.5 to 49.5 mm (1.910 to 1.948 in.)

NOTE:

Be careful not to damage the transfer extension housing type T oil seal.

INSTALL REAR OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
Refer to PROCEDURE - Step 55
INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
Refer to INSTALLATION [08/2015 - ]
ADD TRANSFER OIL
See step 2
CHECK FOR TRANSFER OIL LEAK