Data List / Active Test [08/2019 - 08/2021]
- DATA LIST
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE:In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- Warm up the engine.
- Turn the ignition switch off.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus:
- for Combination Meter: Body Electrical / Combination Meter / Data List
- for ABS/VSC/TRAC: Chassis / ABS/VSC/TRAC / Data List
- for Engine and ECT: Powertrain / Engine and ECT / Data List
- Check the values by referring to the table below.COMBINATION METER
Tester Display Measurement Item/Range Normal Condition Diagnostic Note Tail Cancel SW TAIL cancel switch condition / OFF or ON OFF: TAIL cancel switch off
ON: TAIL cancel switch on- ODO/TRIP Change SW ODO/TRIP switch condition / OFF or ON OFF: ODO/TRIP switch not pushed
ON: ODO/TRIP switch pushed- Vehicle Speed Meter Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost same as actual vehicle speed (when driving) - Engine Rpm Engine speed / Min.: 0 rpm, Max.: 12800 rpm 600 to 700 rpm (When idling) - Coolant Temperature Engine coolant temperature / 16 to 127°C (60.8 to 260.6°F) After warming up: 80 to 95°C (176 to 203°F) - +B Voltage Value Battery voltage / Min.: 0 V, Max.: 25.5 V 11 to 14 V - Fuel Input Fuel input signal / Min.: 0, Max. 127.5 Current fuel level displayed Unit: Liters Ambient Temperature Outside temperature / Min.: -40°C (-40°F), Max.: 50°C (122°F) Almost the same as actual outside temperature The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F). Rheostat value Light control rheostat switch input / Min.: 0, Max.: 100 Light control rheostat switch fully turned downward (0) → fully turned upward (100) Unit: % Multi Switch (Up) Up switch (Steering pad switch assembly) / OFF or ON OFF: Switch released
ON: Switch pushed- Multi Switch (Down) Down switch (Steering pad switch assembly) / OFF or ON OFF: Switch released
ON: Switch pushed- Multi Switch (Menu) Menu switch (Steering pad switch assembly) / OFF or ON OFF: Switch released
ON: Switch pushed- Multi Switch (Enter) OK switch (Steering pad switch assembly) / OFF or ON OFF: Switch released
ON: Switch pushed- Multi Switch (Right) Right switch (Steering pad switch assembly) / OFF or ON OFF: Switch released
ON: Switch pushed- Multi Switch (Left) Left switch (Steering pad switch assembly) / OFF or ON OFF: Switch released
ON: Switch pushed- Oil Pressure Switch Oil pressure switch / OFF or ON OFF: Engine oil pressure low
ON: Engine oil pressure not low- Turn Signal Switch (Right) RH turn signal switch / OFF or ON OFF: RH turn signal switch off
ON: RH turn signal switch on- Turn Signal Switch (Left) LH turn signal switch / OFF or ON OFF: LH turn signal switch off
ON: LH turn signal switch on- Hazard Flasher Switch Hazard warning switch / OFF or ON OFF: Hazard warning signal switch assembly off
ON: Hazard warning signal switch assembly on- Multi Switch (Back) Back switch (Steering pad switch assembly) / OFF or ON OFF: Switch released
ON: Switch pushed- Brake Fluid Amount Brake fluid level / OK or Low OK: Brake fluid level normal
Low: Brake fluid level abnormal- Battery Charge Battery Charge / OK or NG OK: Battery is charged
NG: Battery is not charged- Driver Side Seatbelt Warning Buzzer Condition of driver side seat belt warning buzzer / OFF or ON ON: Driver side seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when driver side seat belt unfastened
OFF: Driver side seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when driver side seat belt unfastenedThe customized setting of the driver side seat belt warning buzzer is displayed. P-Seatbelt Warning Buzzer Condition of front passenger side seat belt warning buzzer / OFF or ON ON: Front passenger side seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when front passenger side seat belt unfastened
OFF: Front passenger side seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when front passenger side seat belt unfastenedThe customized setting of the front passenger side seat belt warning buzzer is displayed. ODO Display Time After IG OFF Setting Condition of the ODO display time after the ignition switch is turned off / 30s, 60s, 600s, OFF Displays customize setting of ODO Display Time After the Ignition Switch is Turned Off - Flasher Sound Volume Adjustment Flasher sound volume customize status / Large, Medium, Small Displays customize setting of Flasher Sound Volume Adjustment - TPMS System Existence of tire pressure warning system / with or without Without: w/o Tire Pressure Warning System
With: w/ Tire Pressure Warning System- LDA System Existence of lane control system / Without or With Without: w/o Lane Departure Alert System
With: w/ Lane Departure Alert System- PCS System Existence of pre-collision system / Without or With Without: w/o Pre-collision System
With: w/ Pre-collision System- Flasher Sound Tone Setting Flasher sound tone customize status / Tone 1, Tone 2, Tone 3 Displays customize setting of Flasher Sound Tone - Intuitive P/A System Existence of intuitive parking assist system / Without or With Without: w/o Intuitive Parking Assist System
With: w/ Intuitive Parking Assist System- Number of Trouble Code Number of DTCs currently stored 0 - HINT:
Although the item is displayed on the Techstream, the vehicle may not have the indicator, warning, buzzer or display.
ABS/VSC/TRACTester Display Measurement Item/Range Normal Condition Diagnostic Note FR Wheel Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost the same as actual vehicle speed measured using a speedometer tester - FL Wheel Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost the same as actual vehicle speed measured using a speedometer tester - RR Wheel Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost the same as actual vehicle speed measured using a speedometer tester - RL Wheel Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost the same as actual vehicle speed measured using a speedometer tester - Vehicle Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost the same as actual vehicle speed measured using a speedometer tester - ENGINE AND ECTTester Display Measurement Item/Range Normal Condition Diagnostic Note Engine Speed Engine speed/Min.: 0 rpm, Max.: 16383 rpm 600 to 700 rpm (When idling) - Coolant Temp Engine coolant temperature/Min.: -40°C (-40°F), Max: 215°C (419°F) 80 to 100°C (176 to 212°F): After warming up - If the value is -40°C (-40°F), the sensor circuit is open.
- If the value is 140°C (284°F) or more, the sensor circuit is shorted.
- ACTIVE TEST
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Combination Meter / Active Test.
- Check the operation by referring to the table below.COMBINATION METER
Tester Display Test Part Control Range Diagnostic Note Speed Meter Operation Speedometer 0, 40, 80, 120, 160, 200 mph*1 Acceptable range (mph): [Control range → Speedometer display] - 40 → 39.7 to 42.5
- 80 → 79.5 to 84
Confirm that the vehicle is stopped with the engine idling.0, 40, 80, 120, 160, 200 km/h*2 Acceptable range (km/h): [Control range → Speedometer display] - 40 → 38.9 to 43.4
- 80 → 79.8 to 84.8
- 120 → 119.1 to 125.9
- 160 → 162 to 167
Confirm that the vehicle is stopped with the engine idling.TachoMeter Operation Tachometer 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 (rpm) Confirm that the vehicle is stopped with the engine idling. Fuel Meter Operation Fuel receiver gauge OFF, Sender E, Empty, Warning, 1/4, 1/2, 3/4, Full, Sender F Confirm that the vehicle is stopped with the engine idling. A/T Indicator Operation 1 A/T shift indicator light (D, P, N, R, 4, 3, 2, L) P, R, N, D, 4 (M), 3 (M), 2, L Confirm that the vehicle is stopped with the engine idling. A/T Indicator Operation 2 A/T gear range indicator light (S, 6, 5) 5, 6, S Confirm that the vehicle is stopped with the engine idling. Indicat. Lamp Airbag SRS warning light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Lamp Doors All Open Door indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Driver Side Seat Belt Driver side seat belt warning light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Lamp ABS ABS warning light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Lamp Charge Charge warning light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Lamp Slip Slip indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Lamp Beam High beam indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Lamp Head Head indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Lamp Tail Tail indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Lamp Fr FOG Front fog indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Pre-Collision PCS indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Lamp Fuel Fuel level warning light OFF / ON Confirm that the vehicle is stopped with the engine idling. ACTIVE TRC Indicator A-TRAC indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. VSC TRC Indicator TRC OFF/TRAC OFF indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Tire Pressure Warning System Tire pressure warning light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. ECONO Eco driving indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Lamp Brake Brake warning light OFF / ON Confirm that the vehicle is stopped with the engine idling. Master Warning Master warning light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. INTUITIVE P/A LCD Clearance sonar OFF indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Auto LSD AUTO LSD indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Downhill Assist Control Downhill assist control indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Park Parking brake warning light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Ctr DIFF LOCK Center differential lock indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. Rr DIFF LOCK Rear differential lock indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. 4LO 4LO indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. A/T P A/T P indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Indicat. VSC OFF VSC OFF indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Automatic High Beam Indicator Automatic high beam indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. KDSS Indicator Kinetic dynamic suspension system indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. PPS Indicator PPS warning light OFF / ON Confirm that the vehicle is stopped with the engine idling. Turn Signal (Left) Indicator Turn L indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Turn Signal (Right) Indicator Turn R indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. 4WD Indicator (Green) 4WD indicator light OFF / ON Confirm that the vehicle is stopped with the engine idling. Check Engine Indicator MIL (Malfunction indicator light) OFF / ON Confirm that the vehicle is stopped with the engine idling. Water Temperature Meter Operation Engine coolant temperature receiver gauge Low, Normal, High Confirm that the vehicle is stopped with the engine idling. Meter Display 1 Multi-information display OFF / All Confirm that the vehicle is stopped with the engine idling. - *1: for Speedometer with Imperial Units for Main Scale
- *2: for Speedometer with Metric Units for Main Scale