Entire Combination Meter does not Operate [07/2014 - ]: Procedure

1. Disconnect the D100 combination meter assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   D100-39 (IG+) - Body ground	Ignition switch ON	11 to 14 V
   D100-40 (B) - Body ground	Always	11 to 14 V

3. Measure the resistance according to the value in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D100-21 (ET) - Body ground	Always	Below 1 Ω

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Combination Meter Assembly)

4. Reconnect the combination meter assembly connector.

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2