Customize Parameters [12/2012 - 10/2015]

CUSTOMIZE METER / GAUGE SYSTEM

Customizing with the Techstream

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Utility / Customize / Warning or Display.

Select the setting by referring to the table below.

Warning

Tester Display	Description	Default	Setting	ECU
Key Remind Sound	Function to change the key reminder buzzer sound frequency	Normal	00:Normal, 01:Slow, 10:Fast	Combination meter assembly
Driver Side Seatbelt Warning Buzzer	Function to turn on/off the seat belt warning buzzer*	ON	0:OFF, 1:ON	Combination meter assembly
Front Passenger Side Seatbelt Warning Buzzer	Function to turn on/off the seat belt warning buzzer*	ON	0:OFF, 1:ON	Combination meter assembly
Lane Change Flashing Times Setting	Function to change the lane change flashing time	3	00:OFF, 01:3, 10:5, 11:7	Combination meter assembly

*: This setting is only valid for the buzzer which sounds at 20 km/h (12 mph) or more.

Display

Tester Display	Description	Default	Setting	ECU
ECO Drive Indicator Zone	Function to enable or disable the eco driving indicator zone display in the multi-information display	OFF	0:OFF, 1:ON	Combination meter assembly
ODO Display Time After IG OFF Setting	Function to change the odometer display time	30s	00:30s, 01:60s, 10:600s, 11:OFF	Combination meter assembly

Unit conversion

Tester Display	Description	Default	Setting	ECU
Units By Region	Function to change the multi-information display unit	Ml/g US1 km/l2	000:Km/l JP, 100:Km/l, 010:Ml/g US, 110:Ml/g UK, 001:km/g	Combination meter assembly

*1: for mph
*2: for km/h

Customizing with the combination meter assembly

Turn the ignition switch to ON.

Select the setting by referring to the table below.

Setting Part	Default	Content	Setting	Relevant ECU
Eco driving indicator light	Eco On	Function to turn on/off the eco driving indicator light	Eco On or Eco OFF	Combination meter assembly