LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> RAV4 LE, AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System (Front) (Service Information) (Except Hybrid) >> Front Brake >> Removal [12/2012 - ] >> Procedure

Removal [12/2012 - ]: Procedure

  1. REMOVE FRONT WHEEL 
  2. DRAIN BRAKE FLUID 
    NOTE:

    Wash off brake fluid immediately if it comes in contact with any painted surface.

  3. DISCONNECT FRONT FLEXIBLE HOSE 
    1. Remove the union bolt and gasket.
      GTY384563Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the flexible hose from the disc brake cylinder.
  4. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH 
    1. Hold the front disc brake cylinder slide pin and remove the 2 bolts and disc brake cylinder.
      GTY362967Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Hold
      *b Turn
  5. REMOVE FRONT DISC BRAKE PAD 
    1. Remove the 2 disc brake pads.
  6. REMOVE FRONT ANTI-SQUEAL SHIM KIT 
    1. Remove the 2 No. 1 anti-squeal shims and 2 No. 2 anti-squeal shims from each pad.
  7. REMOVE NO. 1 PAD WEAR INDICATOR PLATE 
    1. Remove the 2 pad wear indicator plates from the pads.
  8. REMOVE NO. 1 FRONT DISC BRAKE PAD SUPPORT PLATE 
    1. Remove the 2 No. 1 front disc brake pad support plates from the disc brake cylinder mounting.
      GTY362603Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 No. 1 Front Disc Brake Pad Support Plate
      *2 No. 2 Front Disc Brake Pad Support Plate
  9. REMOVE NO. 2 FRONT DISC BRAKE PAD SUPPORT PLATE 
    1. Remove the 2 No. 2 front disc brake pad support plates from the disc brake cylinder mounting.
  10. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING LH 
    1. Remove the 2 bolts and cylinder mounting.
      GTY369722Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN 
    1. Remove the front disc brake cylinder slide pin from the front disc brake cylinder mounting.
      GTY367784Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Front Disc Brake Cylinder Slide Pin
      *2 No. 2 Front Disc Brake Cylinder Slide Pin
  12. REMOVE NO. 2 FRONT DISC BRAKE CYLINDER SLIDE PIN 
    1. Remove the No. 2 front disc brake cylinder slide pin from the front disc brake mounting.
  13. REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSH 
    1. Using a screwdriver, remove the front disc brake cylinder slide bush from the No. 2 front disc brake cylinder slide pin.
      GTY380451Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape

      HINT: 

      Tape the screwdriver tip before use.

      NOTE:

      Be careful not to damage the pin.

  14. REMOVE FRONT DISC BRAKE BUSH DUST BOOT 
    1. Remove the 2 boots from the mounting.
      GTY243374Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  15. REMOVE FRONT DISC 
    1. Put matchmarks on the disc and axle hub.
      GTY365956Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Matchmark
    2. Remove the disc.
scientia non olet · About LEMON Manuals