LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> RAV4 LE, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seats (Service Information) (Except Hybrid) (2 Of 2) >> Power Seat Switch >> Inspection [10/2015 - ] >> Procedure

Inspection [10/2015 - ]: Procedure

  1. INSPECT FRONT POWER SEAT SWITCH 
    GTY691503Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    *1 Slide Switch
    *2 Front Vertical Switch
    *3 Lifter Switch
    *4 Reclining Switch
    *a Component without harness connected
    (Front Power Seat Switch)
    1. Check the resistance of the slide switch.
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        5 - 8
        5 - 7        		 Front position Below 1 Ω
        2 - 11
        2 - 12
        5 - 11
        5 - 12        		 Neutral Below 1 Ω
        2 - 11
        2 - 12
        5 - 11
        5 - 12        		 Rear position Below 1 Ω
        2 - 8
        2 - 7

        If the result is not as specified, replace the front power seat switch.

    2. Check the resistance of the front vertical switch.
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        1 - 8
        1 - 7        		 Up position Below 1 Ω
        6 - 11
        6 - 12
        1 - 11
        1 - 12        		 Neutral Below 1 Ω
        6 - 11
        6 - 12
        1 - 11
        1 - 12        		 Down position Below 1 Ω
        6 - 8
        6 - 7

        If the result is not as specified, replace the front power seat switch.

    3. Check the resistance of the lifter switch.
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        3 - 8
        3 - 7        		 Up position Below 1 Ω
        4 - 11
        4 - 12
        3 - 11
        3 - 12        		 Neutral Below 1 Ω
        4 - 11
        4 - 12
        3 - 11
        3 - 12        		 Down position Below 1 Ω
        4 - 8
        4 - 7

        If the result is not as specified, replace the front power seat switch.

    4. Check the resistance of the reclining switch.
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        10 - 8
        10 - 7
        10 - 1
        10 - 6        		 Front position Below 1 Ω
        9 - 11
        9 - 12
        10 - 11
        10 - 12        		 Neutral Below 1 Ω
        9 - 11
        9 - 12
        10 - 11
        10 - 12        		 Rear position Below 1 Ω
        9 - 8
        9 - 7
        9 - 1
        9 - 6

        If the result is not as specified, replace the front power seat switch.

scientia non olet · About LEMON Manuals