Inspection Procedure

HINT: 

• If DTC P0A0F-524 is output, clear the DTCs, perform the following procedure, and check that the same DTC is not output after the repair.
  1. With the vehicle and engine stopped, the power switch on (READY) and park (P) selected, depress the accelerator pedal to start the engine.
  2. Keep the engine running for 5 seconds or more.
• If DTC P0A0F-525 is output, clear the DTCs, perform the following procedure, and check that the same DTC is not output after the repair.
  1. With the vehicle and engine stopped, the power switch on (READY) and park (P) selected, depress the accelerator pedal to start the engine.
  2. Keep the engine running for 5 seconds or more.