How To Proceed With Troubleshooting [08/2014 - ]

HINT: 

• Perform troubleshooting according to the following flow chart.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. CUSTOMER PROBLEM ANALYSIS 

   NEXT: Go to next step 

3. CHECK CAN COMMUNICATION SYSTEM* 
   1. Check for DTC output. Refer to DIAGNOSIS SYSTEM [08/2014 - ] .

      Result

      Result	Proceed to
      No CAN DTC is output	A
      CAN DTC is output	B

      B → GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2014 - ] 

      A: Go to next step 

4. PROBLEM SYMPTOM CONFIRMATION 

   NEXT: Go to next step 

5. SYMPTOM SIMULATION 

   NEXT: Go to next step 

6. PROBLEM SYMPTOMS TABLE 
   1. Refer to Problem Symptoms Table. Refer to PROBLEM SYMPTOMS TABLE [08/2014 - ] .

      NEXT: Go to next step 

7. CIRCUIT INSPECTION 

   NEXT: Go to next step 

8. REPAIR OR REPLACE 

   NEXT: Go to next step 

9. CONFIRMATION TEST 

   NEXT → END