LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Prius C Three >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Battery Management Systems >> Hybrid Battery System (Diagnostic Codes (P0A7F-123 - U029A-123)) >> Hybrid Battery System >> DTC P0AFC-123: Hybrid Battery Pack Sensor Module [12/2014 - ] >> Confirmation Driving Pattern

Confirmation Driving Pattern

  1. Connect the Techstream to the DLC3.
  2. Turn the ignition switch to ON (IG) and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the ignition switch off and wait for 30 seconds or more.
  5. Turn the ignition switch to ON (IG) and wait for 10 seconds or more.
  6. Perform the universal trip.
  7. Enter the following menus: Powertrain / HV / Trouble Codes.
  8. Read the current DTCs.

    HINT: 

    • If a current DTC is output, the system is malfunctioning.
    • If a current DTC is not output, perform the following procedure.
  9. Check that permanent DTCs are cleared. If no permanent DTC is output, the system is normal.
scientia non olet · About LEMON Manuals