Turn Signal Switch Circuit [12/2014 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. Read the display on the Techstream.
   COMBINATION METER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Turn Signal Switch (Right)	Turn signal switch (Right) signal/ON or OFF	ON: Turn signal switch (Right) on OFF: Turn signal switch (Right) off	-
   Turn Signal Switch (Left)	Turn signal switch (Left) signal/ON or OFF	ON: Turn signal switch (Left) on OFF: Turn signal switch (Left) off	-

   OK

   Normal conditions listed above are displayed.

NG → See step   2 

OK → See step   4 

1. Remove the headlight dimmer switch assembly. Refer to REMOVAL [12/2014 - ] .

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   13 (TR) - 12 (EL)	Turn signal switch in neutral position	10 kΩ or higher
   15 (TL) - 12 (EL)	Turn signal switch in neutral position	10 kΩ or higher
   13 (TR) - 12 (EL)	Turn signal switch in right turn position	Below 1 Ω
   15 (TL) - 12 (EL)	Turn signal switch in left turn position	Below 1 Ω

   TEXT IN ILLUSTRATION
   
   

   *a	Component without harness connected (Headlight Dimmer Switch Assembly)

NG → See step   5 

OK: Go to next step 

1. Disconnect the G3 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G10-13 (TR) - G3-9 (ER)	Always	Below 1 Ω
   G10-15 (TL) - G3-10 (EL)	Always	Below 1 Ω
   G10-12 (EL) - Body ground	Always	Below 1 Ω
   G3-9 (ER) - Body ground	Always	10 kΩ or higher
   G3-10 (EL) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   4