DTC P3147-240: Transmission system; DTC P3147-242: Transmission system [12/2014 - ]: Procedure

CHECK DTC OUTPUT (HYBRID CONTROL)

Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

Check if DTCs are output.

Result

Result	Proceed to
P3147-240 or P3147-242 only is output.	A
P0A1D is also output.	B

Turn the ignition switch off.

B → See step 3

A → See step 2

REPLACE HYBRID VEHICLE TRANSAXLE ASSEMBLY. Refer to COMPONENTS [12/2014 - ]
GO TO DTC CHART (P0A1D). Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2014 - ]