Inspection Procedure

HINT: 

• If DTC P3147-239 is output, clear the DTCs, perform the following procedure, and check that the same DTC is not output after the repair.
  1. Drive the vehicle at approximately 30 km/h (12 mph) or more for approximately 5 seconds or more using the engine.
• If DTC P3147-241 is output, clear the DTCs, perform the following procedure, and check that the same DTC is not output after the repair.
  1. With the vehicle stopped and the shift lever in P, turn the ignition switch to ON (READY) and gradually depress the accelerator pedal so that the engine starts.