DTC P3000-603: Battery Control System [12/2014 - ]: Procedure
- CHECK DTC OUTPUT (HYBRID CONTROL)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON (IG).
- Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
- Check if DTCs are output.
Result
Result Proceed to P3000-603 only is output. A DTCs other than P3000-603 are also output. B - Turn the ignition switch off.
B → See step 3
A: Go to next step
- REPLACE HYBRID VEHICLE CONTROL ECU
Refer to COMPONENTS [12/2014 - ]
NEXT → See step 4
- GO TO DTC CHART (HYBRID CONTROL SYSTEM). Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2014 - ]
- REPLACE HV BATTERY. Refer to COMPONENTS [12/2014 - ]