DTC P0A0F-204: Engine Failed to Start; DTC P0A0F-205: Engine Failed to Start; DTC P0A0F-206: Engine Failed to Start; DTC P0A0F-524: Engine Failed to Start; DTC P0A0F-525: Engine Failed to Start [12/2014 - ]: Procedure

CHECK DTC OUTPUT (ENGINE AND ECT)
1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON (IG).
3. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
4. Check if DTCs are output.
5. Turn the ignition switch off.
NEXT → See step 2
GO TO DTC CHART (SFI SYSTEM). Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2014 - ]