Inspection Procedure

HINT: 

• When SFI system related DTCs are output, the hybrid vehicle control ECU stores DTCs P0A0F-204, 205, 206, 524 or 525.
• If DTC P0A0F-524 is output, clear the DTCs, perform the following procedure, and check that the same DTC is not output after the repair.
  1. With the vehicle and engine stopped, the ignition switch to ON (READY) and the shift lever in P, depress the accelerator pedal to start the engine.
  2. Keep the engine running for 5 seconds or more.
• If DTC P0A0F-525 is output, clear the DTCs, perform the following procedure, and check that the same DTC is not output after the repair.
  1. With the vehicle and engine stopped, the ignition switch to ON (READY) and the shift lever in P, depress the accelerator pedal to start the engine.
  2. Keep the engine running for 5 seconds or more.