Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL
| Monitor runs whenever the following DTCs are not stored | None |
| Both of the following conditions are met | - |
| Lost communication with power management control ECU (U0293) | Not detected |
| Hybrid control module judge | Engine running |
RANGE CHECK/RATIONALITY
| All of the following conditions are met | - |
| Crankshaft position sensor | Signal input |
| Power switch | On (IG) |
| Time after starter off to on | 2.5 seconds or more |
| VVT sensor circuit fail | Not detected |
| Number of VVT sensor signal pulse | 6 times |
| Auxiliary battery voltage | 7 V or higher |
VERIFY PULSE INPUT (CASE 1)
| All of the following conditions are met | - |
| Engine speed | 600 rpm or higher |
| Starter | Off |
| Time after starter on to off | 3 seconds or more |
VERIFY PULSE INPUT (CASE 2)
| Both of the following conditions are met | - |
| Power switch | On (IG) |
| Time after power switch off to on (IG) | 0.5 seconds or more |