LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Highlander XLE, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Automatic Transmission (UA80E) - Diagnostic Codes (2 Of 3)) >> Automatic Transaxle System >> DTC U1103-87: Lost Communication with Stop and Start Control Module Missing Message [11/2016 - ] >> Description

DTC U1103-87: Lost Communication with Stop and Start Control Module Missing Message [11/2016 - ]: Description

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

The ECM and engine stop and start ECU send and receive signals via CAN communication.

If a communication error occurs between the ECM and engine stop and start ECU, the ECM stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
U110387 Lost Communication with Stop and Start Control Module Missing Message 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
  1. The ignition switch is ON and battery voltage is 10 V or more.
  2. No communication between ECM and engine stop and start ECU
  3. 1.16 seconds or more
  4. 1-trip detection logic
  • ECM
  • Engine stop and start ECU
  • CAN communication system
 Does not come on DTC stored SAE Code:
U1103
scientia non olet · About LEMON Manuals