LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Highlander XLE, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Automatic Transmission (UA80E) - Service Information (1 Of 2)) >> Park / Neutral Position Switch >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Move the shift lever to N.
    2. Temporarily install the park/neutral position switch assembly to the automatic transaxle case sub-assembly with the 2 bolts.
      NOTE:

      Before installing the park/neutral position switch assembly, remove any dirt or rust on the manual valve lever shaft sub-assembly. Be sure to install the park/neutral position switch assembly straight along the manual valve lever shaft sub-assembly while being careful not to deform the plate spring that supports the manual valve lever shaft sub-assembly. If the plate spring is deformed, the park/neutral position switch assembly cannot be installed correctly.

    3. Temporarily install the transmission control shaft lever to the park/neutral position switch assembly.
    4. Turn the transmission control shaft lever clockwise until it stops, then turn it counterclockwise 2 notches.
      GTY703061Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a P Position
      *b N Position
    5. Remove the transmission control shaft lever from the park/neutral position switch assembly.
    6. Align the protrusion with the neutral basic line.
      GTY739354Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Neutral Basic Line
      *b Protrusion
    7. Hold the park/neutral position switch assembly in that position and tighten the 2 bolts.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    8. Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the washer and nut.

      Torque: 12.7 N*m (130 kgf*cm, 9 ft.*lbf) 

    9. Connect the park/neutral position switch assembly connector.
  2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Connect the transmission control cable assembly to the transmission control shaft lever and install the clip.
      NOTE:

      Before connecting the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in neutral.

  3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY 
    1. Engage the guide to the grommet of the air cleaner support bracket to temporarily install the air cleaner case sub-assembly.
    2. Install the air cleaner case sub-assembly with the 2 bolts.

      Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

  4. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 
    1. Install the air cleaner filter element sub-assembly to the air cleaner case sub-assembly.
  5. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 3

  6. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION 

    See step  2

  7. INSPECT SHIFT LEVER POSITION 

    See step  2

  8. ADJUST SHIFT LEVER POSITION 

    Refer to ADJUSTMENT [11/2016 - ] 

scientia non olet · About LEMON Manuals