Inspection [12/2013 - ]: Procedure
- INSPECT SPOT LIGHT ASSEMBLY LH (for Front Side or Rear Side)
- Apply battery voltage to the connector and check that the spot light comes on.
*a Component without harness connected
(Spot Light Assembly LH (for Front Side or Rear Side))OK
Measurement Condition Condition Specified Condition Battery positive (+) → 2 (B)
Battery negative (-) → 4 (E)Spot light switch on Spot light comes on Spot light switch off Spot light does not come on Battery positive (+) → 2 (B)
Battery negative (-) → 3 (CTY)Spot light switch on Spot light does not come on Spot light switch off Spot light comes on If the result is not as specified, replace the bulb or spot light assembly LH (for Front Side or Rear Side).
- Apply battery voltage to the connector and check that the spot light comes on.
- INSPECT SPOT LIGHT ASSEMBLY RH (for Front Side or Rear Side)
- Apply battery voltage to the connector and check that the spot light comes on.
*a Component without harness connected
(Spot Light Assembly RH (for Front Side or Rear Side))OK
Measurement Condition Condition Specified Condition Battery positive (+) → 2 (B)
Battery negative (-) → 4 (E)Spot light switch on Spot light comes on Spot light switch off Spot light does not come on Battery positive (+) → 2 (B)
Battery negative (-) → 3 (CTY)Spot light switch on Spot light does not come on Spot light switch off Spot light comes on If the result is not as specified, replace the bulb or spot light assembly RH (for Front Side or Rear Side).
- Apply battery voltage to the connector and check that the spot light comes on.