DTC P0116: Engine Coolant Temperature Circuit Range / Performance [02/2014 - 11/2016]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read the DTCs.
Powertrain > Engine and ECT > Trouble Codes
Result
Result Proceed to DTC P0116 is output A DTC P0116 and other DTCs are output B HINT:
If any DTCs and other than P0116 are output, troubleshoot those DTCs first.
Result: 2
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [02/2014 - 08/2014] Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2014 - 11/2015] Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2015 - 11/2016]
Result: 1
A
See step 2
- INSPECT THERMOSTAT
- Inspect the thermostat (thermostat opening temperature).
Refer to INSPECTION [02/2014 - 11/2016]
HINT:
Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Refer to INITIALIZATION [02/2014 - 11/2016]
Result
Proceed to OK NG
Result: 1
OK
REPLACE ENGINE COOLANT TEMPERATURE SENSOR. Refer to REMOVAL [02/2014 - 11/2016]
Result: 2
NG
REPLACE THERMOSTAT. Refer to REMOVAL [02/2014 - 11/2016]
- Inspect the thermostat (thermostat opening temperature).