LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Highlander XLE, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting System (Exterior) - Service Information - (Except Hybrid) >> Daytime Running Light Assembly >> Inspection [12/2013 - 11/2016] >> Procedure

Inspection [12/2013 - 11/2016]: Procedure

  1. INSPECT DAYTIME RUNNING LIGHT ASSEMBLY LH 
    1. Apply battery voltage to the daytime running light assembly LH and check that the light comes on.
      GTY430333Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Daytime Running Light Assembly LH)

      OK

      Condition Specified Condition
      Battery positive (+) → Terminal 1 (E)
      Battery negative (-) → Terminal 2 (B)      		 Daytime running light LH comes on

      If the result is not specified, replace the daytime running light assembly LH.

  2. INSPECT DAYTIME RUNNING LIGHT ASSEMBLY RH 
    1. Apply battery voltage to the daytime running light assembly RH and check that the light comes on.
      GTY430333Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Daytime Running Light Assembly RH)

      OK

      Condition Specified Condition
      Battery positive (+) → Terminal 1 (E)
      Battery negative (-) → Terminal 2 (B)      		 Daytime running light RH comes on

      If the result is not specified, replace the daytime running light assembly RH.

scientia non olet · About LEMON Manuals