Installation [12/2013 - 11/2016]: Procedure

1. Install the V-ribbed belt.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Engine Water Pump Assembly
   *2	No. 2 Idler Pulley Sub-assembly
   *3	Generator Assembly
   *4	Crankshaft Pulley
   *5	V-ribbed Belt Tensioner Assembly
   *6	Compressor Assembly with Pulley

   NOTE:

   • Put the backside of the V-ribbed belt on the V-ribbed belt tensioner pulley and No. 2 idler pulley sub-assembly.
   • Check that the V-ribbed belt is properly set to each pulley.
2. Turn the V-ribbed belt tensioner counterclockwise and remove the 5 mm hexagon wrench.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the crankshaft pulley by hand.

See step  91

1. Install the front fender liner RH with the bolt, 4 screws and 4 clips.

Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)