Diagnosis System [11/2016 - ]
- DESCRIPTION
- Automatic high beam system data and Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.
- CHECK DLC3
- Check the DLC3.
Refer to GENERAL INFORMATION [12/2013 - ]
- Check the DLC3.
- INSPECT BATTERY VOLTAGE
- Measure the battery voltage.
Standard Voltage
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery.
- Measure the battery voltage.
- DIAGNOSIS SYSTEM
- If the automatic high beam system malfunctions, the automatic high beam indicator light turns off and "Headlight System Malfunction Visit Your Dealer" is displayed on the multi-information display.
HINT:
In this case, the main body ECU (multiplex network body ECU) stores DTCs.
Refer to DTC CHECK / CLEAR [12/2013 - ]
- If the automatic high beam system malfunctions, the automatic high beam indicator light turns off and "Headlight System Malfunction Visit Your Dealer" is displayed on the multi-information display.