Installation [12/2013 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL V-RIBBED BELT
- Set the V-ribbed belt onto each part as shown in the illustration except the engine water pump pulley.
*1 Crankshaft Pulley *2 V-ribbed Belt Tensioner Assembly *3 Generator Assembly *4 Engine Water Pump Assembly *5 Cooler Compressor - Loosen the V-ribbed belt by turning the belt tensioner clockwise.
- Set the V-ribbed belt onto the engine water pump pulley.NOTE:
Make sure that the V-ribbed belt is securely fitted into the grooves of each pulley.
- Set the V-ribbed belt onto each part as shown in the illustration except the engine water pump pulley.