Typical Enabling Conditions
P0715:
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
P0717:
| The monitor will run whenever this DTC is not present. | P0746, P0776, P0796, P2808 (Shift solenoid valve (functional) P0748, P0778, P0798, P2810 (Shift solenoid valve (range) |
| Shift change | Shift change is completed before starting next shift change operation |
| ECM selected gear | 2nd, 3rd, 4th, 5th or 6th |
| Output shaft RPM | 1, 000 RPM or more |
| R switch | OFF |
| NSW switch | OFF |
| Engine | Running |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
| Transmission range switch circuit | Not malfunction |
| Turbine speed sensor range check | Not malfunction |