DTC P0711: Transmission Fluid Temperature Sensor "A" Performance [09/2014 - ]: Procedure
- CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0711)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read the DTCs using the Techstream.
Result
Display (DTC Output) Proceed to Only P0711 is output A P0711 and other DTC B HINT:
If any other codes besides P0711 are output, perform troubleshooting for those DTCs first.
B → See step 3
A: Go to next step
- CHECK TRANSMISSION FLUID LEVEL
- Check the transmission fluid level. Refer to ADJUSTMENT [09/2014 - ]
.
OK
Automatic transmission fluid level is correct.
NG → ADJUST FLUID LEVEL
OK → See step 4
- Check the transmission fluid level. Refer to ADJUSTMENT [09/2014 - ]
.
- GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2014 - ]
- REPLACE TRANSMISSION WIRE (ATF TEMPERATURE SENSOR). Refer to COMPONENTS [09/2014 - ]