LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Camry LE >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (Diagnostic Codes & Circuit Tests) (U760E) (Except Hybrid) >> Automatic Transaxle System >> DTC P0705: Transmission Range Sensor Circuit Malfunction (PRNDL Input) [09/2014 - ] >> Inspection Procedure

Inspection Procedure

NOTE:
  • Perform the universal trip to clear permanent DTCs. Refer to DTC CHECK / CLEAR [09/2014 - ] .
  • Inspect the fuses for circuit related to this system before performing the following inspection procedure.

HINT: 

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Warm up the engine.
  2. Turn the ignition switch off.
  3. Connect the Techstream to the DLC3.
  4. Turn the ignition switch to ON.
  5. Turn the Techstream on.
  6. Enter the following menus: Powertrain / Engine and ECT / Data List.
  7. According to the display on the Techstream, read the Data List.
    Tester Display Measurement Item / Range Normal Condition Diagnostic Note
    Neutral Position SW Signal PNP switch status / ON or OFF
    • ON: Shift lever is in P or N
    • OFF: Shift lever is not in P or N
    		 When the shift lever position displayed on the Techstream differs from the actual position, adjustment of the PNP switch or the shift cable may be incorrect.
    Shift SW Status (P Range) PNP switch status / ON or OFF
    • ON: Shift lever is in P
    • OFF: Shift lever is not in P
    		 When the shift lever position displayed on the Techstream differs from the actual position, adjustment of the PNP switch or the shift cable may be incorrect.
    Shift SW Status (R Range) PNP switch status / ON or OFF
    • ON: Shift lever is in R
    • OFF: Shift lever is not in R
    		 When the shift lever position displayed on the Techstream differs from the actual position, adjustment of the PNP switch or the shift cable may be incorrect.
    Shift SW Status (N Range) PNP switch status / ON or OFF
    • ON: Shift lever is in N
    • OFF: Shift lever is not in N
    		 When the shift lever position displayed on the Techstream differs from the actual position, adjustment of the PNP switch or the shift cable may be incorrect.
    Shift SW Status (D Range) PNP switch status / ON or OFF
    • ON: Shift lever is in D or S
    • OFF: Shift lever is not in D or S
    		 When the shift lever position displayed on the Techstream differs from the actual position, adjustment of the PNP switch or the shift cable may be incorrect.
    Sports Mode Selection SW Sport mode select switch status/ ON or OFF
    • ON: Shift lever is in S, "+" or "-"
    • OFF: Shift lever is not in S, "+" or "-"
    		 -
scientia non olet · About LEMON Manuals