DTC C2198/98: Initialization Switch (for Test Mode DTC) [09/2014 - ]: Procedure

1. Disconnect the tire pressure warning reset switch connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Switch Condition	Specified Condition
   1 (INT) - 2 (E)	On	Below 1 Ω
   	Off	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *a	Component without harness connected (Tire Pressure Warning Reset Switch)
   *b	On
   *c	Off

NG → See step   3 

OK: Go to next step 

1. Disconnect the I186 tire pressure warning reset switch connector and O25, O33 or N41 tire pressure warning ECU and receiver connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   O25-3 (CLSW) - I186-1 (INT)*1 O33-3 (CLSW) - I186-1 (INT)*2 N41-3 (CLSW) - I186-1 (INT)*3	Always	Below 1 Ω
   O25-3 (CLSW) - Body ground*1 O33-3 (CLSW) - Body ground*2 N41-3 (CLSW) - Body ground*3	Always	10 kΩ or higher
   I186-2 (E) - Body ground	Always	Below 1 Ω

   • *1: w/o Intuitive Parking Assist System with Smart Key System
   • *2: w/o Intuitive Parking Assist System without Smart Key System
   • *3: w/ Intuitive Parking Assist System

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   4