Inspection Procedure
NOTE:
- When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
- w/ Tire Inflation Pressure Display Function:
It is necessary to perform initialization. Refer to INITIALIZATION [09/2014 - ] after registration. Refer to REGISTRATION [09/2014 - ] of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.
- w/o Tire Inflation Pressure Display Function:
It is necessary to perform registration. Refer to REGISTRATION [09/2014 - ] of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.
- When replacing the tire pressure warning ECU and receiver on vehicles equipped with the wireless door lock control system (w/o smart key system), be sure to perform Registration of Recognition Code to register the transmitter IDs after ECU replacement. Refer to REGISTRATION [09/2014 - ] .
HINT:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.