LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Camry LE >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Wireless Charging System (Diagnostics & Circuit Tests) (Except Hybrid) >> Wireless Charging System >> Circuit Tests >> Wireless Charger Power Source Circuit [09/2014 - ] >> Procedure

Wireless Charger Power Source Circuit [09/2014 - ]: Procedure

  1. CHECK HARNESS AND CONNECTOR (UPPER CONSOLE PANEL SUB-ASSEMBLY POWER SOURCE) 
    1. Disconnect the I179 upper console panel sub-assembly connector.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      I179-5 (PGND) - Body ground Always Below 1 Ω
    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection Condition Specified Condition
      I179-1 (ACC) - I179-5 (PGND) Engine switch on (ACC) 11 to 14 V

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → See step   2 

  2. PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [09/2014 - ]  
scientia non olet · About LEMON Manuals