Disassembly [09/2014 - ]

HINT: 

• Use the same procedure for the RH side and LH side.
• The following procedure is for the LH side.

1. REMOVE REAR WHEEL 
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY  . Refer to REPLACEMENT [09/2014 - ] - Step 2
3. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG 
4. REMOVE REAR DISC  . Refer to REMOVAL [09/2014 - ] - Step 14
5. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Front Side) 
   1. Remove the parking brake shoe return tension spring.
      Fig 1: Identifying Parking Brake Shoe Return Tension Spring (For Front Side)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Rear Side) 
   1. Remove the parking brake shoe return tension spring.
      Fig 2: Identifying Parking Brake Shoe Return Tension Spring (For Rear Side)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. REMOVE PARKING BRAKE SHOE HOLD DOWN COMPRESSION SPRING (for Front Side) 
   1. Using SST, remove the parking brake shoe hold down compression spring.
      Fig 3: Removing/Installing Parking Brake Shoe Hold Down Compression Spring

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09718-00011 
8. REMOVE PARKING BRAKE SHOE STRUT 
   1. Pull the No. 1 parking brake shoe assembly towards the front of the vehicle by hand as shown in the illustration.
      Fig 4: Removing No. 1 Parking Brake Shoe Assembly

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Remove the parking brake shoe strut.
      Fig 5: Removing/Installing Parking Brake Shoe Strut

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
9. REMOVE PARKING BRAKE SHOE HOLD DOWN COMPRESSION SPRING (for Rear Side) 
   1. Using SST, remove the parking brake shoe hold down compression spring.
      Fig 6: Removing/Installing Parking Brake Shoe Hold Down Compression Spring

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09718-00011 
10. SEPARATE PARKING BRAKE SHOE LEVER 
    1. Expand the No. 1 and No. 2 parking brake shoe assemblies outward by hand and pull downward to separate them from the parking brake plate.
       Fig 7: Separating Parking Brake Shoe Lever

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Separate the parking brake shoe lever from the No. 2 parking brake shoe assembly.
11. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET 
    1. Remove the parking brake shoe adjusting screw set.
       Fig 8: Identifying Parking Brake Shoe Adjusting Screw Set

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
12. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY 
    1. Remove the No. 1 parking brake shoe assembly.
       Fig 9: Identifying No. 1 Parking Brake Shoe Assembly

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
13. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Lower Side) 
    1. Remove the parking brake shoe return tension spring.
       Fig 10: Identifying Parking Brake Shoe Return Tension Spring (For Lower Side)

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
14. REMOVE PARKING BRAKE SHOE LEVER 
    1. Using needle-nose pliers, remove the parking brake shoe lever from the No. 3 parking brake cable assembly as shown in the illustration.
       Fig 11: Removing Parking Brake Shoe Lever From No. 3 Parking Brake Cable

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
15. REMOVE PARKING BRAKE SHOE HOLD DOWN SPRING PIN 
    1. Remove the parking brake shoe hold down spring pin (for front side).
       Fig 12: Removing/Installing Parking Brake Shoe Hold Down Spring Pin (For Front Side)

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the parking brake shoe hold down spring pin (for rear side).
       Fig 13: Removing/Installing Parking Brake Shoe Hold Down Spring Pin (For Rear Side)

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002