Inspection [09/2014 - ]

INSPECT AIR CONDITIONING CONTROL ASSEMBLY (HAZARD SWITCH)

Measure the resistance according to the value(s) in the table below.

Fig 1: Inspecting Air Conditioning Control Assembly (Hazard Switch) Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Standard Resistance

Tester Connection	Switch Condition	Specified Condition
4 (HAZ) - 6 (GND)	Hazard switch off	10 kΩ or higher
4 (HAZ) - 6 (GND)	Hazard switch on	Below 1 Ω

TEXT IN ILLUSTRATION

*a	Component without harness connected (Air Conditioning Control Assembly (Hazard Switch))

If the result is not as specified, replace the air conditioning control assembly.