LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Camry LE >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Automatic Headlight Beam Level Control System (Exterior) (Diagnostic Codes & Circuit Tests) (Except Hybrid) >> Automatic Headlight Beam Level Control System >> Circuit Tests >> LVL Terminal Circuit [09/2014 - ] >> Procedure

LVL Terminal Circuit [09/2014 - ]: Procedure

  1. CHECK HARNESS AND CONNECTOR (DLC3 - HEADLIGHT LEVELING ECU ASSEMBLY) 
    1. Disconnect the A34 headlight leveling ECU assembly connector.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      A34-5 (SPDL) - I39-8 (LVL) Always Below 1 Ω
      A34-5 (SPDL) - Body ground Always 10 kΩ or higher

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: Go to next step 

  2. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND) 
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      I39-4 (CG) - Body ground Always Below 1 Ω

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → See step   3 

  3. PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [09/2014 - ] 
scientia non olet · About LEMON Manuals