Headlight Signal Circuit [09/2014 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / HL Auto Leveling / Data List.
5. Read the display on the Techstream.
   HL AUTO LEVELING
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Headlight Low Beam State	Low beam headlight state/ON or OFF	ON: Low beam headlights on OFF: Low beam headlights off	-

   OK

   Normal conditions listed above are displayed.

NG → See step   2 

OK → See step   4 

1. Disconnect the 3D instrument panel junction block assembly connector.
2. Disconnect the A34 headlight leveling ECU assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   3D-11 - A34-3 (B2)	Always	Below 1 Ω
   3D-11 - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Remove the instrument panel junction block assembly. Refer to REMOVAL [09/2014 - ] .

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   3D-11 - 3D-12	Always	Below 1 Ω
   3D-11 - Body ground	Always	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *a	Component without harness connected (Instrument Panel Junction Block Assembly)

NG → See step   6 

OK → See step   5