LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Camry LE >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Audio / Video System (W/ DVD Player) (Diagnostic Codes & Symptom Tests) (Except Hybrid) >> AUDIO AND VISUAL SYSTEM (W/ DVD Player) >> Circuit Tests >> Radio Receiver Power Source Circuit [09/2014 - ] >> Procedure

Radio Receiver Power Source Circuit [09/2014 - ]: Procedure

  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY POWER SOURCE) 
    1. Disconnect the I64 and I67 radio and display receiver assembly connectors.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      I64-7 (GND1) - Body ground Always Below 1 Ω
    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection Condition Specified Condition
      I64-4 (+B1) - I64-7 (GND1) Always 11 to 14 V
      I64-3 (ACC1) - I64-7 (GND1) Ignition switch ACC 11 to 14 V
      I67-1 (IG) - I64-7 (GND1) Ignition switch ON 11 to 14 V

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → See step   2 

  2. PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [09/2014 - ] 
scientia non olet · About LEMON Manuals