DTC U1000: CAN Communication Failure (Message Registry) [09/2014 - ]: Procedure
- CHECK FOR DTCs (HEALTH CHECK)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: System Select / Health Check.
- Check for DTCs.RESULT
Result Proceed to DTC U1000 only is output A DTCs other than U1000 are output B
B → See step 3
A → See step 2
- REPLACE LANE DEPARTURE WARNING CAMERA. Refer to REMOVAL [09/2014 - ]
- GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2014 - ]