DTC C1AA3: Vehicle Speed Sensor Circuit [09/2014 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
5. Check for DTCs. Refer to DTC CHECK / CLEAR [09/2014 - ] .

   Result

   Result	Proceed to
   Vehicle stability control system DTCs are not output	A
   Vehicle stability control system DTCs are output	B

B → See step   3 

A: Go to next step 

1. Clear the DTCs. Refer to DTC CHECK / CLEAR [09/2014 - ] .
2. Make sure that the DTC detection conditions are met.

   HINT: 

   If the detection conditions are not met, the system cannot detect the malfunction.

3. Check for DTCs. Refer to DTC CHECK / CLEAR [09/2014 - ] .

   Result

   Result	Proceed to
   DTC C1AA3 is not output	A
   DTC C1AA3 is output	B

B → See step   5 

A → See step   4