DTC C2177/77: Initialization not Completed [10/2014 - ]: Procedure

CHECK FREQUENCY RECEIVING CONDITION
1. Check that the vehicle is not located in an area such as described below:
  1. Facilities or devices that use similar radio frequencies are located in the vicinity of the vehicle.
    HINT:
    
    If the vehicle is located in an area such as the one described above, the tire pressure warning light may illuminate after blinking 1 minute due to interfering radio frequencies.
  2. Devices using similar radio frequencies are used in the vehicle.
    OK
    
    Facilities or devices that use similar radio frequencies are not located in the vicinity of the vehicle.
    
    HINT:
    
    Radio transmissions may be interrupted due to the surroundings, or devices installed by the user.
Result:

NG

CHECK IF ANY DEVICE IS INSTALLED BY USER

Result:

OK

See step 2
PERFORM INITIALIZATION
1. Perform initialization (Refer to INITIALIZATION [10/2014 - 10/2015] or INITIALIZATION [10/2015 - ] ).
Result:

NEXT

See step 3

CONFIRM TIRE INFLATION PRESSURE (DATA LIST)

Turn the engine switch off.
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

Check the values by referring to the table below.

TIRE PRESSURE MONITOR

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
ID 1 Tire Inflation Pressure	ID1 tire inflation pressure/ min.: Absolute pressure (abs) / 50 kPa (0.5 kgf/cm² , 7 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm² , 0 psi) max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm² , 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm² , 55 psi)	Actual tire inflation pressure	If N/A is displayed, data has not been received.*1
ID 2 Tire Inflation Pressure	ID2 tire inflation pressure/ min.: Absolute pressure (abs) / 50 kPa (0.5 kgf/cm² , 7 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm² , 0 psi) max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm² , 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm² , 55 psi)	Actual tire inflation pressure	If N/A is displayed, data has not been received.*1
ID 3 Tire Inflation Pressure	ID3 tire inflation pressure/ min.: Absolute pressure (abs) / 50 kPa (0.5 kgf/cm² , 7 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm² , 0 psi) max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm² , 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm² , 55 psi)	Actual tire inflation pressure	If N/A is displayed, data has not been received.*1
ID 4 Tire Inflation Pressure	ID4 tire inflation pressure/ min.: Absolute pressure (abs) / 50 kPa (0.5 kgf/cm² , 7 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm² , 0 psi) max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm² , 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm² , 55 psi)	Actual tire inflation pressure	If N/A is displayed, data has not been received.*1

HINT:

*1: It may take a few minutes until the values are displayed.
When an "ID Tire Inflation Pressure" value has not changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees. Then rapidly release the tire pressure and recheck the value.

Result

Result	Proceed to
All tire pressure readings are equal to specified values.	A
Tire pressure values are not displayed.	B

Result:

END

Result:

GO TO DTC C2121/21 TO C2124/24