Inspection [10/2014 - ]: Procedure
- INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH
- Before installing the rear seat inner with center belt assembly LH, check the ELR function.NOTE:
Do not disassemble the retractor.
- When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.TEXT IN ILLUSTRATION
*1 Retractor *a Unlocked *b Locked *c 45° If the result is not as specified, replace the rear seat inner with center belt assembly LH.
- When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.
- Before installing the rear seat inner with center belt assembly LH, check the ELR function.