How To Proceed With Troubleshooting [10/2014 - 10/2015]: Procedure

Result

Result: 

NEXT 

See step  2

Result: 

NEXT 

See step  3

1. Measure the battery voltage.

   Standard Voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

Result: 

NEXT 

See step  4

1. Use the Techstream to check if the CAN communication system is functioning normally (Refer to DIAGNOSIS SYSTEM [10/2014 - 10/2015] ).

   Result

   Result	Proceed to
   CAN communication system DTCs are not output.	A
   CAN communication system DTCs are output.	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 10/2015] )

Result: 

A 

See step  5

1. Refer to Problem Symptoms Table (Refer to PROBLEM SYMPTOMS TABLE [10/2014 - ] ).

   Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table.	A
   Fault is listed in Problem Symptoms Table.	B

Result: 

B 

See step  7

Result: 

A 

See step  6

1. Data List / Active Test (Refer to DATA LIST / ACTIVE TEST [10/2014 - ] )
2. Terminals of ECU (Refer to TERMINALS OF ECU [10/2014 - ] )
3. Operation Check (Refer to OPERATION CHECK [10/2014 - ] )

Result: 

NEXT 

See step  7

Result: 

NEXT 

See step  8

Result: 

NEXT 

END