Inspection [10/2014 - ]: Procedure
- INSPECT TIRE PRESSURE WARNING RESET SWITCH
- Remove the tire pressure warning reset switch (Refer to REMOVAL [10/2014 - 10/2015] Refer to REMOVAL [10/2015 - ] ).
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 (INT) - 2 (E) On Below 1 Ω Off 10 kΩ or higher TEXT IN ILLUSTRATION*a Component without harness connected
(Tire Pressure Warning Reset Switch)*b On *c Off
- Remove the tire pressure warning reset switch (Refer to REMOVAL [10/2014 - 10/2015] Refer to REMOVAL [10/2015 - ] ).